C-RTK 9P RTK Receiver
Description
The C-RTK 9Ps is a four-star Real Time GNSS system, using two C-RTK 9Ps modules, one for aircraft and the other for base stations. It also supports the dual GPS for yaw, replacing the uav magnetic compass, so that the UAV can adapt to the complex magnetic field environment. Compared with C-RTK 9P, C-RTK 9Ps achieves similar performance at lower price; It is a very cost-effective centimeter-level positioning module. Compatible with PX4/ArduPilot open-source flight controller. It is an ideal choice for uav aerial performance, agricultural application, high-precision takeoff and landing, ship takeoff and landing and other applications requiring real-time high-precision navigation.
Purchase
Key Features
| Hardware Parameters | |
|---|---|
| Receiver type | 184 channel ZED-F9P(ublox) |
| Compass | IST8310 |
| GNSS | GPS、Beidou、Galileo、GLONASS |
| Number of concurrent GNSS | 4 |
| GNSS Bands | GPS-L1C/A(1575.42MHz） GPS - L2C（1227.6MHz） GLONASS - L1OF（1602MHz) GLONASS- L2OF(1246MHz）; GALILEO - E1B/C（1575.42MHz） GALILEO- E5b(1207.14MHz）; BeiDou - B1I（1561.098MHz) BeiDou - B2I(1204.14MHz); QZSS - L1C/A(1575.42MHz) QZSS - L2C(1227.6MHz） |
| Nav. update rate | RTK 20Hz RAW 25Hz; PVT 25Hz (The maximum limit is related to the concurrency setting; please refer to the subsequent navigation refresh rate chapter for details) |
| Position accuracy | RTK：0.01m+1ppm CEP GPS：1.5m CEP; SBAS：1.0m CEP |
| RTK Surveyin-time | RTK<60s |
| Acquisition | Cold starts<24s Hot starts<1s |
| Sensitivity | Cold starts –148 dBm Hot starts –157 dBm Reacquisition –160 dBm |
| Anti-jamming | Active CW detection and removal Onboard band pass flter |
| Anti-spoofng | Advanced anti-spoofng algorithms |
| Antenna gain | Rover：2dBi Base：5dBi |
| PPK | not support |
| GPS heading | Support (requires two C-RTK 9Ps); heading accuracy: 0.4edg (reference value) |
| Base/Rover role swap | Support |
| UART | 2 UART |
| USB | 1 |
| Protocols | NMEA、UBX binary、RTCM 3.x |
| Operating voltage | 4.5V to 6V |
| Operating temperature | –40°C to +85°C |
Size and Weight
Pinouts
Nav. update rate
Hardware connection
As the first GPS:
- Use a special cable to connect the C-RTK 9Ps (UART1) interface to the flight control GPS interface.
As a second GPS:
- Use a dedicated line to connect the C-RTK 9Ps (UART1) interface to the flight control UART4 interface.
- If the flight controller is running ArduPilot firmware, please set GPS_TYPE2 to 1.
GPS+safety switch (USL module):
USL modules need to be purchased separately; you can also use ordinary safety switches to rewire for DIY.