HV PM
The HV_PM module is a power monitor independently developed by CUAV and has the following characteristics:
- 10v-60v voltage input (3s~14s battery)
- Highly accurate measurement of voltage and current
- Integrated 5V5A BEC
- Maximum 60A current
The main function:
- Provide 5V voltage output and maximum 5A current to power the autopilot.
- Detect the current voltage and output an analog signal to the autopilot
- Detect the current system current and output an analog signal to the autopilot.
It is very simple to use. The one with the chip faces you. The left side is connected to the battery, and the right side is connected to the load (motor/ESC). The 6Pin signal line is connected to the Power interface of the autopilot.
Data sheet
| Data sheet | |
|---|---|
| Operating Voltage | 10~60V（3-14s Lipo） |
| Current(MAX) | 60A |
| Current error | +-0.2A |
| voltage error | +-0.1V |
| Interface current | |
| Power | 5.3V/4A |
| Interface type | |
| Battery interface | XT60 |
| 12V out 5V out FC Power |
GH1.25 |
| Size | 320mm x20mm |
| Weight | 29g |
Size
Monitor settings(Missiplanner)
Power module settings for V5 series autopilot(Ardupilot)