Skip to content

IST8 External Compass ​

The IST8 compass module integrates the IST8310, a 3×3 mm LGA-packaged geomagnetic sensor from iSentek, and is widely used in UAV products. PX4 and ArduPilot have applied it to smart controllers as an external compass.

IST8

Hardware parameters ​

IST8
CompassIST8310
Operating temperature-40~85℃
Power input5V
InterfaceI2C
Weight5g
Dimensions23×14×9mm

Installation ​

IST8

Connect the IST8 compass to the smart controller's I2C port, and make sure the arrow in the image above points in the same direction as the front of the smart controller.

Supported firmware ​

CUAV V5 smart controller firmware is fully compatible with this external compass, with both Pixhawk and ArduPilot firmware supported. Consult customer service when using it with other smart controllers.

Compass calibration ​

See the compass calibration page.

More information ​

IST8310 data sheet