Skip to content

Usage Guide for Ardupilot ​

This guide mainly describes how to use SKYE2 with Ardupilot.

提示

SKYE2 supports Ardupilot 4.30 and above firmware.

Enable ​

Set the following parameters in all parameter tables of Mission planner and restart after writing

  • CAN_P1_DRIVER set to 1.
  • CAN_P2_DRIVER set to 1.
  • CAN_D1_PROTOCOL set to 1.
  • CAN_D2_PROTOCOL set to 1.
  • ARSPD_TYPE set to 8.
  • ARSPD_USE set to 1.
  • ARSPD_AUTOCAL set to 1.

Temperature and Humidity Data ​

ArduPilot 4.30 and above firmware supports temperature and humidity sensor data display:

SKYE

Calibrate airspeed offset ​

When there is no wind and the airspeed display is greater than 3 m/s, perform airspeed offset calibration before takeoff:

  • Connect the smart controller and open Mission Planner.
  • Make sure the pitot tube is in a windless environment.
  • Open Mission planner>Flight data>Action bar.
  • Select "Preflight Calibration" and click "Perform Action".
off

Pre-flight inspection ​

Before flying, please connect to the ground station to check that there is no wind and ensure that the airspeed value is within the range of 0~3m/s (if it exceeds the range, need perform airspeed offset calibration)

off
  • Hold the pitot tube with your hand and blow air into the pitot tube. If the airspeed value changes according to the airflow speed, the inspection is complete.
off

Airspeed Calibration ​

说明

Different installation methods and airspeed sensor scale factors will be different. The airspeed indicator needs to be calibrated on the first flight. Set smart controller parameter ARSPD_AUTOCAL to 1 to enable automatic calibration.

Perform calibration (choose one of the following two methods):

  1. Take off in QStabilize or QLoiter multi-axis mode and switch to FBWA (self-stabilizing A mode) to control the drone to fly and hover for about 5 circles. After the ground station message bar prompts that the calibration is completed, execute the landing.
  2. If you don’t know how to fly in FBWA mode, you can fly with the airspeed sensor enabled but without it (ARSPD_USE=1; ARSPD_TYPE=8; do not do this in an environment with high wind speed); The aircraft will fly at ground speed (relative to ground speed). After takeoff, it will circle in Loiter mode for about 5 circles. The ground station message bar will prompt that the calibration is completed before landing.