System Restore
For LTE LINK SE
If the current system is not running properly, restore it using the steps below.
Note
Perform this operation only when the system has a fault. If you simply cannot connect to the network, check the network instead. Make sure the device can access the network before restoring.
Before restoring
The restore is performed over the network, so a valid SIM card and antenna must be connected to the device.
Restore steps
- Power on the device while holding the button. When "checked restore" appears on the OLED screen, the device has entered restore mode.
- When the OLED screen shows "Flash rootfs", the device is downloading the normal system files. Wait for the download to complete.
- When the download is complete, the device starts the automatic update process and the OLED message changes from "Flash rootfs" to "INSIST". Wait for the device to finish starting; it will finally boot into the latest normal version.
For AIR LINK
Note
Perform this operation only when the system has a fault. If you simply cannot connect to the network, check the network instead. Make sure the device can access the network before restoring.
If the device fails to start normally, restore it to the original version.
Note
The restored version does not support data communication. Wait for the online upgrade to complete before using it normally.
- Hold the "Bind" button and power on the AIR LINK. When the button has been held for more than 3 s, the signal LED turns blue; release the button to enter the restore process.
- When the restore finishes, the blue signal LED turns off and the device restarts automatically. Do not power off during the restore, or the device may be damaged.

