FAQ
Is there a distinction between receiver and transmitter?
No. The SX Radio has a built-in automatic switching chip and does not distinguish between receiver and transmitter (or aircraft end and ground end). When USB is plugged in, data is switched to the USB port; when USB is absent, data is switched to the 6P GH1.25 port.
Factory default parameters
The factory defaults are an air data rate of 115K, an interface rate of 57600 and point-to-point broadcast mode. Generally, only the VID needs to be changed to isolate it from other modules. Read the documentation and modify other settings with care.
Ground end power requirement
The ground end must ensure USB port supply current greater than 250 mA; independent power supply is recommended where possible. Some older laptops, phones and tablets may not be able to supply enough power.
Short range with a phone OTG connection
Range may be shorter when using a phone OTG connection because OTG power is insufficient.
How to connect to the controller
Plug the PixHack series into the controller's Radio port; plug the Pixhawk series into the controller's TELEM1 or TELEM2 port. When used as a wireless telemetry module with other systems, connect according to the pinouts (RX–TX, TX–RX, GND–GND); the default interface rate is 57600 and can be changed as needed.

